Ricmotech recommends hard mounting the pedals directly to your sim-racing chassis. The mounting positions suggested are only
that, a suggestion. Please feel free to change the placement of the pedals to accommodate your preferred driving style.
Suspended pedals should be mounted at a height of about 17 inches (43cm) above the sim-chassis floor. The pedals should be
mounted so the brake pedal is approximately even with the throttle pedal when it is fully depressed, typically about 1 inch (25mm),
but this may vary based upon the pedal firmness setting. Mount the pedals using ¼ inch or 6mm thick bolts or screws (not included).
Use nuts and washers to be sure the screws will not pull out.
Your pedals may include a
mounting frame to facilitate the placement of your pedals.
Position the remote
sensor assembly as shown in the image below. Be sure the hose is
not stretched or kinked.
Route the cables to avoid having them get pinched or chafed using zip ties. Mount the PCU (Pedal Control Unit) in a location that is
both out of the way yet within reach of the driver, such as next to your wheel.
Open the brake fluid reservoir and pry out the rubber plug. This plug is only to prevent spills during transport. Keep the plug in case
the pedals or rig need to be moved in the future.
