28
SCT-1100 Weight Transmitter
Printing and Zeroing Totals
The instrument has two different total levels, a partial total and a general total, which increase with each
totalization. These can be printed and zeroed independently from each other.
To print and zero a partial total, press
. The number of weighs and the net weight total is printed.
• With normal totalization the number of weighs and the accumulated total displays
• With fast or automatic totalization
displays
To print and zero the general total, press and hold
. The number of weighs and the net weight total is printed. If
an output setpoint is configured, it is possible to enter a submenu and choose the parameter to be modified; select
.
• With normal totalization the number of weighs and the accumulated total displays.
• With fast or automatic totalization the message
displays.
All the accumulated values are automatically reset each time the instrument is turned off.
If an output setpoint is configured, it is possible to enter a submenu and choose the parameter to be modified;
select
.
Setpoint Setting
Press
for about 3 seconds. If an output setpoint is configured, it is possible to enter a submenu and choose the
parameter to be modified; select
3.10.11Vertical Totalizer
The vertical totalizer is the same as the horizontal totalizer, except with each press of
the indicated weight is
totalized and automatically tared. It is used, for example, in filling a container with multiple products.
At the end of totalization functions, press
to view the gross weight on the scale.
3.10.12Counting
This mode allows for the instrument to be used as a counting scale. In the setup mode,
,
after pressing
to confirm
, the following parameters must be set.
1.
(unit of measure of the average piece weight) displays. Press
to enter the menu.
2. Press
or
until the desired value displays. (
,
,
,
)
3. Press
to
confirm.
4. Press
until
displays. Press
to confirm and store to the instrument memory or press any other
key to cancel and exit without saving.
5.
(sampling interval) displays. Press
to enter the menu.
6. Set the desired time. Press
to select the digit to be modified and
or
to increase or decrease the
digit. Press
to confirm.
7. Slowly press multiple times until
displays.
• Press
to confirm and store to the instrument memory
• Press any other key to cancel and exit without saving
Key Function
Press and hold
to:
• enter a known average piece weight (APW). See
Manual Entry of APW on page 30
• set a setpoint; if an output after reaching a setpoint is configured, it is possible to enter a submenu to choose
the parameter to be modified; select
(
)
Press and hold
:
• if there is not a reference – set a reference value. see
for more information
• if there is a reference – the reference value and number of pieces/weight on the scale alternate on the display
Note
Note
C
C
C