Rice Lake SCT-1000ETHERNET, Operation Manual

Page: 10 / 28

SCT-1000Ethernet / SCT-2200WIFI
6 Visit our website www.RiceLake.com
5. In Ethernet Status, click Properties. See step 5 in Figure 2-6 .
6. Highlight Internet Protocol Version 4 (TCP/IPV4) and click Properties.See step 6 in Figure 2-6 .
7. Toggle Use the following IP address . See step 7 in Figure 2-6 .
• Enter any IP address between 192.168.16.0 and 192.168.16.255, except 192.168.16.205 or 192.168.16.254
• Subnet mask is 255.255.255.0
• Gateway is empty
8. Click ok and close on all open windows to enable static IP address.
Figure 2-6. Ethernet Status
2.3.2 Setting upWi-Fi
When the SCT-2200 Wi-Fi has been connected to power it will automatically begin transmitting a Wi-Fi signal. See Figure 2-7 .
• Default SSID is HI-LINK_5C53
• Default password is 12345678
To reset the SSID and password, See Section 4.3 on page 16 .
Figure 2-7. Default SSID
2.4 Resetting the SCT-1000 Ethernet
The SCT-1000 Ethernet can be reset and return it to its initial settings at any time. To reset the SCT-1000 Ethernet:
1. Switch off the device.
2. Open the device to access the jumper DFLT.
3. Close the jumper DFLT.
4. Switch on the device. The red and green LEDs blink repeatedly.
5. Complete the reset by opening the jumper and restarting the module.
5.
6.
7.