RoughDeck CS Rail Car Coil Scale
4
Visit our website
2.3 Temporary Setting Blocks
Most installers use setting blocks that are approximately 3" high for the initial placement and connecting of the deck module.
Use leveling bolts in the base plate to level the scale. Setting blocks are only used in the corners of the module where the load
cell mounts are installed.
When placing modules on setting blocks, place the blocks in a location close to, but not at the load cell pocket (to
allow room for mount).
Figure 2-2. Setting Blocks Under Weighbridge Module
Note
7.5"
3"
12.5"
15.5"
