Rice Lake REVOLUTION 682 Synergy Plus, Technical Manual

Page: 93 / 130

EDP Commands
© Rice Lake Weighing Systems ● All Rights Reserved 85
12.2 Reporting Commands
Reporting commands send specific information to the communications port. The commands listed in Table 12-2 can be used in
either Setup mode or Weigh mode.
12.3 SD Card Commands
The following commands can be used to store or restore a backup copy of the indicator configuration to an SD Card.
Indicator must be in Setup mode.
NOTE: Backing up or restoring indicator configuration to/from a microSD card only works if a microSD card is installed.
12.4 Reset Configuration Command
The following command can be used to reset the configuration parameters of the 682.
NOTE: All scale calibration settings are lost when the RESETCONFIGURATION command is run
.
Kn This command acts like pressing numbers 0 (zero) through 9
KDOT This command acts like pressing the decimal point (.)
KENTER This command acts like pressing the Enter key
KLOCK=x In Weigh mode, this command locks specified front panel key; x = KPRINT, KUNITS, KTARE, KGROSSNET, KZERO,
K0-K9, KDOT, KCLEAR (example: to lock the Zero key, enter KLOCK=KZERO)
KUNLOCK=x In Weigh mode, this command unlocks specified front panel key; x = KPRINT, KUNITS, KTARE, KGROSSNET, KZERO,
K0-K9, KDOT, KCLEAR (example: to unlock the Print key, enter KUNLOCK=KPRINT)
Table 12-2. Reporting Commands
Command Function
DUMPALL Returns a list of all parameter values
DUMPAUDIT Returns the Audit Trail information
KDUMPAUDIT Returns the Audit Trail information on the same port which the EDP command was sent
AUDIT.LRVERSION Returns the legally relevant firmware version
AUDIT.CONFIG Returns the number of times configuration has changed
AUDIT.CALIBRATE Returns the number of calibrations
AUDITJUMPER Returns the position of the audit jumper: OK (if the audit jumper is ON) or ?? (if the audit jumper is OFF)
SPDUMP Returns a list of the setpoint parameter values
VERSION Returns the installed firmware version
FIELDBUS.VERSION Returns the installed Fieldbus card’s firmware version; returns V0.00.00 if no Fieldbus card is installed
BUILD Returns the firmware version and build number
HARDWARE Returns the option card installed
HWSUPPORT Returns the CPU board part number
RTCBATTERYSTATUS Returns the status of the real time clock battery: GOOD or BAD
Table 12-3. Reset Configuration Command
Command Function
SDCARD.STORE Store (backup) the current configuration to the installed microSD card; Answers OK if successful
SDCARD.LOAD Loads a stored backup configuration from the installed microSD card; Answers OK if successful
Table 12-4. Reset Configuration Command
Command Function
RESETCONFIGURATION Restores all configuration parameters to default values ( Setup mode only)
Table 12-1. Key Press Commands (Continued)
Command Function