Rice Lake Legend 480-2A, Technical Manual

Page: 63 / 85

56 480 Legend Series
6.1.6 Normal Mode Commands
The serial transmit weight data commands (see Table 6-15) transmit data to the selected port on demand. The SX
and EX commands are valid only in weigh mode; all other commands are valid in either setup or weigh mode.
Command Description Response Format
UID View and set unit ID when in setup mode.
In Weigh mode, the value can be changed temporarily. It
will reverts to last saved value at next power up. nnnnnn
DATESET View or set date. The response will be in the format, and uses the
separators as defined in configuration. To Set, first
query the date, then send
DATESET= , in exactly the
same format (except use only 2 digits for the year).
TIMESET View or set time. The response will be in the format, and uses the
separators as defined in configuration. To Set, first
query the time, then send
TIMESET= followed by the
time in exactly the same format as the query,
including seconds, and AM or PM if 12 hour.
SX Start streaming on Port 2.
The Trigger Mode of Port 2 must be set to one
of the five stream modes for this command to
function.
OK or ??
EX Stop streaming on Port 2
The Trigger Mode of Port 2 must be set to one
of the five stream modes for this command to
function.
OK or ??
RS Soft reboot —
XA Transmit accumulator value nnnnnn UU
Where nnnnnn is the weight value, UU is the units.
XG Transmit gross weight in displayed units
XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XG2 Transmit gross weight in non-displayed units
XN2 Transmit net weight in non-displayed units
XT2 Transmit tare weight in non-displayed units
XE Query system error conditions nnnnn nnnnn
See Section 9.0 for detailed information about the XE
command response format.
Table 6-15. Normal Mode Commands
Note
Note