Rice Lake Laser-LT-100, Technical Manual

Page: 10 / 19

Configuration
© Rice Lake Weighing Systems ● All Rights Reserved 5
3.0 Configuration
This section provides an overview of LaserLT-60 and LaserLT-100 configuration.
3.1 Quick Setup Menu
Press when the firmware version is displayed during power on to enter the
Setup
( Quick Setup ) menu.
The Quick Setup menu contains options for remote display configuration.
Navigate configuration parameters by using the function keys, see Table 1-2 on page 3 for navigation assistance.
Use and to move across the menu and use to move to the next level.
Figure 3-1. Setup Navigation
Menu Parameter Description
SEtUP
(Setup)
dSP.rF
Display Radio Frequency – Display refresh; Settings:
norN
,
1hz
,
2.5 hz
,
5 hz
,
10 hz,
,
20 hz
SEriAL
Serial – Access to serial port parameters
inPutS
Inputs – Settings:
inP.01
,
inP.02
outPut
Output – Settings:
out.01
,
out.02
an.out
Annunciator Output – Settings:
Capac
,
mode
,
Ao max
,
ao zer
,
ao min
,
Sign
dEFAu
Default – Resets each parameter to the default setting
SEriAL
(Serial)
PC SEL
PC Select – PC serial selection; Settings:
485
,
232
CoN.Prn
Communication Print – Printer Serial
CoN.PC
Communication PC – Port configuration for incoming data
CoM.PC
(Communication PC)
PCModE
PC Mode – Port setting for baud rate, bits, and time out
baud
Baud – Common baud rate selection; Settings:
1200
,
2400
,
4800
,
9600
,
19200
,
38400
,
57600
,
115200
bit
Bit – Set parity, word, and stop bit; Settings:
n-8-1
,
e-7-2
,
e-7-1
,
n-7-2
,
n-8-2
Add.En
Add.En – Settings:
yes
,
no
t.out
Timeout – Sets the timeout communication; Select a value from 0.5–20; the default value is 1.5 seconds;
Maximum value is 20 seconds and the minimum value is 0.5 seconds
PCModE
(PC Mode)
rEPE.6
REPE.6 – Reception of the SCT 2200 string
W.rEPE
U.REPE.6 – Configurable mode that allows identification and location of data in the string;
Default configuration for the Rice Lake continuous format by default ( Section 3.3 on page 7 )
Pr1577
PR 1577 – Reception of the
Pr1577
string
rEPE.dC
REPE.DC – Used when the indicator is connected to digital load cells while connected to the same network
rEPE.in
REPE.In – Auto lean mode that allows reading of the received string automatically without setting any parameters
A.rEPE
Auto.REPE – Alpha numeric mode that allows ASCII text to be displayed when a string is six characters followed
by <CR>
Table 3-1. Setup Parameter Definitions
SEtUP
dSP.rF SEriAL inPUtS
PC SEL Com.Prn
Com.PC
PCModE bAUd bit t.oUt
rEPE.in A.rEPE
rEPE.6 W.rEPE
PR1577 rEPE.dC
oUtPUt dEFAU An.out
diAG F.modE