14
IQ plus 710 Installation Manual
3.1.3
Front Panel Configuration
The IQ plus 710 indicator can be configured using a series of menus accessed through the indicator front panel
when the indicator is in setup mode. Table 3-1 summarizes the functions of each of the main menus.
Figure 3-2. Five-Key Keypad Functions in Setup Mode
Menu
Menu Function
CONFIG
Configuration
Configure grads, zero tracking, zero range, motion band, overload, tare function, power-up
mode, and digital filtering parameters.
FORMAT
Format
Set format of primary and secondary units, decimal format, and display rate.
CALIBR
Calibration
Calibrate indicator. See Section 4.0 on page 33 for calibration procedures.
SERIAL
Serial
Configure EDP and printer serial ports.
PROGRM
Program
Set date and time formats, truck mode, passwords, keyboard locks, regulatory mode, and
initial consecutive number value; enable accumulator; define macro prompts and program
macros.
PFORMT
Print Format
Set print format used for header, gross, net, truck in/out, setpoint, and EDP format tickets. See
Section 6.0 for more information.
SETPNTS
Setpoints
Configure setpoints, batching mode, and assign setpoint names.
DIG IN
Digital Input
Assign digital input functions.
ALGOUT
Analog Output
Configure analog output module. Used only if analog output option is installed.
VERSION
Version
Display installed software version number.
Table 3-1. IQ plus 710 Menu Summary
ZERO
GROSS
NET
TARE
UNITS
B/G
Units
Move LEFT /
Previous
Move RIGHT /
Next
Move UP /
Increment Value
Move DOWN /
Decrement Value
ENTER Value
SETUP MODE 5-KEY FUNCTIONS
