LaserLight3 ConnexLink Wireless Radio Installation
© Rice Lake Weighing Systems
● All Rights Reserved
5
14. Attach the transceiver cable 9-pin connector to the ConnexLink I/O port and finger tighten retaining screws.
Figure 11. Connect Transceiver Cable 9-Pin Connector to ConnexLink
15. Clean mount surface with Isopropyl Alcohol, and let dry.
16. Peel protective backing off adhesive standoffs and position ConnexLink with power jack at top (vertically) in left side of
LaserLight3 enclosure.
IMPORTANT: Ensure ConnexLink position will not obstruct enclosure door operation or make contact with circuit boards.
17. Apply firm pressure to adhesive pads for 30 seconds.
Figure 12. Attach ConnexLInk with Adhesive Standoffs to Enclosure
7-18VDC
I/O
Antenna
7-1
8V
DC
I/O
An
te
nn
a
