12
Competitor Series Installation & Operation Manual
3.5
Connecting the Digital Display to the Scale Base
Connect the digital display to the scale base using the supplied DB-9 connector. Connect the six foot length of
cable into the back of the scale base labeled “Scale” on the back of the unit as shown in Figure 3-3 on page 11.
3.6
Replacing Thermal Printer Paper
Use the following steps to replace the thermal printer paper in the digital display unit. Replacement thermal printer
paper (Rice Lake part number 75947) can be purchased by going to www.ricelakehealth.com..
Figure 3-4. Replacing Thermal Paper in Printer Unit
1. Replace thermal paper while the power is on.
2. Pull the top button up. Then press the side button. Open the upper printer cover.
3. Put the roller into the center hole of the thermal paper.
4. Insert the thermal paper with the roller into the holder as shown in the picture.
5. Take the edge of the paper out and pull paper past the cover.
6. Close the cover.
7. It automatically cuts the paper.
3.7
Jammed Printer Paper Removal
Use the following steps if the printer paper gets jammed in the unit.
1. If the thermal paper gets jammed pull the lower printer cover up as shown in Figure 3-5 and press the jam
button located inside the printer.
2. Remove the jammed paper.
Press the jam
button located
inside the printer.
Figure 3-5. Jammed Printer Paper Removal
