Page 17 / 23
If used outdoors, use only extension cords intended for outdoor use.
Inspect extension cord periodically and replace it if damaged.
- The switch (if fitted on product) becomes damaged, it should be properly repaired or replaced by an
authorized service centre to avoid a hazard. Do not use the product if the switch does not turn it on and off.
- Warning
The use of any accessory or attachment, other than those recommended in this instruction manual, may present
a risk of injury to persons or animals and may cause damages.
- Have your product repaired by a qualified person.
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in an
authorized service centre is recommended.
This electric product is in accordance with the relevant safety requirements. Repairs should only be carried out
by qualified persons using original spare parts, otherwise this may result in considerable danger to the user
3.3- Special warnings when using this electrical product
1. Become familiar with the controls and the proper use of the product.
2. The use of this product by children, without adult supervision, is forbidden.
3. Only well-instructed adults should operate the product.
3. Only adults who have received adequate instructions should use this product.
This product is not intended for use by persons (including children) with reduced physical, sensory or mental
capacities, or persons without experience or knowledge, unless they are supervised by a person responsible for
their safety, or given prior instructions concerning the use of the product.
4. This luminaire is fitted with built-in LED lamp.
5. The LED lamps cannot be replaced.
6. Do not use the luminaire if the safety glass is broken or cracked. Replace or have the safety glass replaced
before re-using the product.
7. In general, do not look directly into the light beam, do not direct the light beam towards people or animals,
and especially do not point towards the eyes or face.
IV. GETTING STARTED
Before
any
intervention
on
product,
disable
the
main
circuit
breaker.
4.1- Electrical connection
Warning! It is recommended to disable the main circuit breaker.
If in doubt, seek assistance from a qualified person to carry out the electrical
connection
The product is delivered with H05RN-F 3G1.0mm
2
cable to connect the luminaire to your electrical
installation.
Cable Preparation
At each end of the cable, strip the 3 wires (blue,
brown, green/yellow) by approx. 6mm with a wire
stripper.
Stripped wires should be copper clad.
Note: Try to leave the ground wire (green/yellow)
slightly longer than the other 2 wires by approx.
5mm.
