MEMO
code ACG7065 for SPARK 230-120Vac
code ACG7066 for SPARK 24 Vdc
The MEMO card indicates to the end user when he should call the
installer for the routine maintenance of the system.
When installing the MEMO card, the installer can determine the
number of cycles for the automation, by using the micro-switches it
is provided with. When the automation carries out the given number
of cycles, a LED of the MEMO card turns on (only if the gate is active)
and warns you need to carry out the routine maintenance of the
system.
The 24 Vdc version for direct current operators is provided with a
second LED (LOW BATTERY), indicating the battery-fed operation
(LED constantly turned on) and when the battery is discharged
(blinking LED).
ACTIVATING THE MEMO CARD
1. Clear the system.
2. Remove the blinker cap (fig. 1-2).
3. Insert the card (fig. 3-4).
4. Select the automatic learning mode «DATA LEARNING» (DIP 1 on
mode ON) (fig. 5).
5. Energize the system.
6. Operate one opening and one closing cycle of the gate. While
opening and closing, the «SERVICE» LED turns on and emits a
steady light signal for the first 3 seconds, then it blinks indicating
the storage is in progress. Note: It is important not to stop the gate
during the storage process or that safety devices are not activated:
the procedure shall be therefore carried out carefully.
7. When the gate is closed, set the «DEMO MODE» (DIP 1-2-3-4
positioned on OFF) and carry out 2 full operation cycles. During
the opening of the 3rd cycle, the «SERVICE» LED turns on, thereby
signaling the correct functioning of the card.
8. By moving the micro-switches as the card serigraphy indicates,
enter the number of cycles, after which the system shall warn you
to carry out the maintenance.
9. Remove the blinker cap (fig. 6).
CHECKING THE CARD FUNCTIONING
You can check the functioning of the MEMO card whenever you want
to. Just select the «DEMO MODE» and make sure the LED turns on
(point 7).
WARNING: When the checking procedure is concluded, position the
micro-switches back where they were, in order to prevent data on
already stored cycles from being cancelled. At every micro-switch
change, a RESET of the cycles carried out until that moment takes
place.
You do not loose stored data if you select the»DEMO MODE».
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 6
Fig. 5
Fig. 6
G
B