DO NOT overtighten or use power tools to assemble.
ASSEMBLY INSTRUCTIONS
Place the Table Top (1) on a level surface so the
Mounting Tube (4) faces up.
1
2
1
3
5
DO NOT remove the Black Screw from Column Assembly until Table is fully assembled. This product utilizes a high
tension, spring loaded mechanism and could raise suddenly causing personal injury.
Install the Column Assembly (2) by inserting the
Outer Tube (6) and Inner Rod (5) through the
Mounting Tube (4). Add the Spacer (14) and Tilt
Adjustment Knob (13) to the Inner Rod (5) and tighten.
Take the Base (7) with the caster holes facing away
from the Table Top (1) and place the end with the mounting
holes on the Column Assembly (2). Insert the 2 large hex
bolts (12) through the Bolt Plate (11), through the Bolt
Sleeves (10), through the Base (7) and into the Column
Assembly (2). Then tighten with a wrench.
Insert the Locking Casters (8) into the Base near the
Column Assembly and insert the Non-Locking Casters
(9) into the opposite end of the Base (7) . Be sure to press
the casters in until they lock into place.
Turn the table upright placing the Casters on the floor.
While pressing down on the Table Top, remove the Black
Screw (15) in the Column Assembly (2) and
replace it with
Chrome Screw B (17) included in the hardware package.
DO NOT REMOVE Chrome Screw A (16) below marked
“Do Not Remove”.
OPERATING INSTRUCTIONS
Apply light upward pressure anywhere on the table top and stop when the desired height is reached.
1
To Raise Table Top
Pull the Adjustment Lever upward and push down on the table top at the Column end. Do not put pressure on the opposite
end. When the Adjustment Lever is released, the Table Top will lock into place.
To Lower Table Top
The Casters on the Column end can be locked by stepping down on the tabs. To unlock, pull up on the tabs.
To Lock and Unlock Casters
Turn the Tilt Adjustment Knob to the left to loosen. Tilt the Table Top to the desired angle and turn the Tilt Adjustment Knob
to the right to tighten.
To Tilt Table Top
