In|Sync Thermal Camera Installation Guide v1.0
3
Introduction
FLIR Thermal is a small, bullet type, easy to install camera unit, delivering high-quality images at
up to 200ft from the stop bar. The camera provides accurate and reliable imaging to help improve
traffic flow by using heat signatures on which the smallest of detail can be seen. The sensors are
designed for long-term exposure to the sun by means of shortpass filters. Each detector has an
anti-reflective coating on its surface and comes with an optional rain/sun shield.
This IP66- and IP67-rated unit meets all NEMA specifications on temperature, vibration, dust and
water resistance. The unit features in-built heaters and a high-performance fixed lens.
Installation is straight-forward and employs a standard mounting bracket and a pole attached
to the traffic signal mast arm with a cable clamp bracket. The hardware components are easy to
assemble and maintain in the long run.
Tools Needed
a)
Hex key tool, included with the camera
b)
5/16” or 8 mm socket and/or wrench
c)
9/16” or 15 mm socket and/or wrench
d)
Network cable tester (Fluke CIQ-100 or equivalent)
e)
Size 3 slotted screwdriver
Installation Steps
1. Attach the universal camera mounting bracket using the provided 4xM5 bolts. Use a
5/16” or 8 mm socket and/or wrench to attach the universal camera bracket to the enclosure.
