Page 7
RHOX Steel and Aluminum Utility Boxes
1. Place the utility box on top of the support frames so the tailgate is at the rear of the
cart.
2. Push the utility box towards the front of the cart and center it between the front and
back of the cart until it is even.
3. Center the box between the driver and passenger sides of the cart.
4. Using a marking device, mark the (4) hole locations onto the underside of the utility
box.
5. Remove the box from the
cart and place it upside-
down on a clean piece of
cardboard to avoid
damage.
6. Use a center punch to
make a dimple at each of
the (4) marked locations.
Use a small drill bit to drill
a pilot hole. Work up to a
7/16” drill bit for the final
hole size. Remove any
burrs with a small file.
7. Fasten the utility box to the support
frames using (4) 10mm x 35mm Phil-
lips Head Truss Bolts, (4)10mm Flat
Washers and (4) 10mm Nylock Nuts.
8. Fasten the latch catches to the tailgate
using (2) 10-32 x 1” Pan Head Phillips
Machine Screws, (2) Flat Washers and
(2) 10-32 Nylock Nuts (black arrow).
NOTE: Orient the latch catch as shown: