RHOSS KCF/B, Instructions For Use Manual

Page: 6 / 38

ELECTRONIC CONTROL FOR TERMINAL UNITS
6
KPLTB - KPLTW -
LIT-Touch wire control panel, complete with LED
display for displaying the desired room temperature or set-point,
capacitive touch keys for setting the room set-point, fan speed (AUTO ,
MIN, MED, MAX) and the manual / automatic summer / winter operating
mode and ventilation (OFF / E / I / Auto / Fan) and room air temperature
probe.
Wall mounting installation to cover any recessed electrical box 503.
Available in glossy black (KPLTB) and pearl white (KPLTW).
Only in conjunction with control (K)CF/P.
Dimensions 120x86x17mm
KPLTB KPLTW
KTLT - IR remote control LIT-Touch for remote control with KRLT
receiver, complete with support for wall mounting.
Only in conjunction with KRLT receiver and control (K)CF/P.
Dimensions 60x160x30 mm
KRLT - IR LIT-
Touch receiver to control remotely with the KTLT remote
control, complete with an ambient air temperature probe, operating
mode LED and emergency micro-key in the case of no remote control.
Wall mounting installation.
Only in conjunction with control (K)CF/P.
Dimensions 95 x 58 x 30 mm
KRLTI -
Infrared receiver card for KTLT remote control to be fixed on
ABS plafond on DIVA / DIVA-I.
Note: not LEDs are present to indicate the functioning mode.
KRLTM - Infrared receiver card for KTLT remote control to be fixed
near the metal plafon.
Note: not LEDs are present to indicate the functioning mode.
KDO2/DO2 - Additional board with 2 digital relay outputs, which can be
configured as ON/OFF call, summer/winter call, unit alarm.
On board installation on control (K)CF/..
Note: the contacts are without voltage (clean contacts).
KIF485 – SS -
RS485 serial interface board for SYS-TO (System Touch
Manager) by Rhoss or third-party supervision (Protocols supported:
Modbus® RTU).
KSTA1 / 3 - On-board air temperature probe, operating in alternative
to the working probe on the KPLT control panel or on the KRLT
receiver.
KSTA1 is a 0.6m long probe for onboard installation on control (K) CF
/ P on Yardy.
KSTA3 is a 3m long probe for channel installation on control (K) CF /
P on YardyHP.
I.1.1 DECLARED CONDITIONS OF USE
The electronic controls referred to in this manual are intended for use
with the following RHOSS terminal units: YardyEV3, YardyDuct, Yardy-
I, YardyID, YardyHp, DIVA, DIVA-I.
These terminal units are not designed to be installed in rooms used for
laundry purposes (IEC standard EN 60335-2-40).
DANGER!
The installation of the terminal units is only
foreseen inside in environments for domestic and
similar use.
I.1.2 SPARE PARTS AND ACCESSORIES
IMPORTANT!
Only Use original spare parts and accessories. RHOSS
S.p.a. shall not be held liable for damage caused by
tampering with or work carried out by unauthorised
personnel or malfunctions caused by the use of non-
original spare parts or accessories.