1
.
3
Connecting the cooler to the Power Supply
Please observe all of the warnings and procedures stated in section 1.1.
Please take care not to pinch or damage the power cord in any way. Please examine
the power cord for any splits, cuts or damage. If it is unsatisfactory then it must be
replaced according to the instructions stated in 1.1.
Plug in the cooler and turn on the power.
Switch on the appliance using the red power switch on the front control panel.
The appliance is designed to run automatically. Defrosting is automatic. The condensate
water is evaporated automatically by the system.
Maintenance must be performed according to the procedures detailed in section 3 of
these instructions.
2
.
0
OPERATION
2
.
1
Operation of the Appliance
6
Power switch
Light switch
The electronic controller has been factory set to chill the beverages to approximately
2 Centigrade. Should you wish to alter the set point, please adopt the following procedure;
2
.
2
Adjustment of the temperature
Press and hold for 4 seconds to enter the menu.
(DEF) To activate a manual defrost, press this button.
(UP) Increases the parameter value.
(DOWN) Decreases the parameter value.
Step 1: Press and hold the “SET” button for approximately 4 seconds
Step 2: Press the set button quickly once more and the current set
point temperature will be displayed.
Step 3: Press the up or down arrow buttons to adjust the setting temperature.
Step 4: Press and hold the SET button for approximately 4 seconds and your
new selection will be stored. If you fail to press SET, the controller will
time out and revert to the previously stored setting.
WARNING!
Please do not alter the value shown at F2. It must remain at 4 for the cooler to
invalidate the guarantee.
