Operating The Trigger
By pulling the trigger [B], a cushion of compressed air is built up inside the
cylinder, which initiates the flow of coatings. On releasing the trigger, the
coatings flow stops as the compressed air escapes through a quick
exhaust valve. It is recommended to start with a regulator pressure setting
of 45 PSIG.
Adjusting The Coating Flow
Adjusting the coating flow is achieved with the pressure regulator at the
rear [A] or handle end [F] of the cartridge gun. To increase the flow of
coating, turn the knob on the regulator in a clockwise direction. To
decrease the flow, turn the knob in a counter-clockwise direction.
To insure proper mix start with front of cartridges pointed up to displace
any air trapped inside cartridges. Once both liquids are flowing you are
ready to spray.
Texture Control
Regulate the texture by adjusting the air flow to the spray tip by opening or
closing the control valve [E]. Opening the valve will give a fine texture and
closing the valve will increse the droplet size.
Unloading Cartridge Pack
Point the front to the cartridge gun upwards. To enable the cartridges to be
removed, the cartridge plungers must first be returned to the start position
by activating the automatic reverse air option as far as it will go.
Caution
• The line pressure connected to the cartridge gun should not exceed
145 PSI (10 bar).
Operating Instructions 5
