OPERATION INSTRUCTIONS FOR
ROLLING CODE ALARM RCA-2
MADE IN AUSTRALIA
HIGH SECURITY SWITCH
Located in the rear of the siren is a master switch. This can
be used to turn the system on/off. Bear in mind that if you
unplug the alarm while it is armed, the built in backup
battery will continue to power the system.
KEYSWITCH POSITIONS
SYSTEM OFF
SYSTEM ON
BACK UP BATTERY TEST
The RCA is fitted with an automatic battery backup test feature. When you are driving the
vehicle dash led will normally be off. If the backup battery is flat then the dash led will flash
with the ignition on.
EMERGENCY PANIC BUTTON OPERATED VIA REMOTE
The panic feature is activated by pressing the right button on the remote control
transmitter for 3 seconds. This sets off the siren. To cancel “panic”, press the
right button on the transmitter for 1 second. NOTE: Panic does not work when
the ignition is on by requirement of Australian Law (EPA).
L
R
TO ARM/DISARM ALARM
Alarm is activated by pressing the button on remote control transmitter. The blinkers will flash once,
and siren will beep once, dash LED-light will stay on for 20 seconds then flash, ALARM IS NOW
ON. To deactivate alarm, press the right button again. Blinkers will flash twice and the siren will
beep twice. ALARM IS OFF.
For audible arm / disarm
use the RIGHT button.
For silent arm / disarm
hold BOTH buttons down for approximately 4 seconds.
ALARM TRIGGER MEMORY
If the alarm was triggered by an intruder while your alarm was set, it will beep the siren four times
on disarm.
BOOT RELEASE - Available on cars fitted with electric boot release motors.
The RCA-2 is fitted with remote boot release. This feature enables the user to unlock the boot by
pressing the left button for 3 seconds. The boot will unlock and the alarm will disarm without
