RHINO RAv2, Instruction Manual, Page: 9 / 20

9
How to Change REGISTER 1:
Vehicle Set Up: A
LL
D
OORS
CLOSED AND T
HE
I
GNITION
T
URNED
O
N
L
AST
Remote Key action: T
URN
O
N
/ O
FF
F
EATURES
V
IA
T
HE
L
EFT
B
UTTON
O
N
T
HE
R
EMOTE
FEATURE
Press
Remote
This Many
Times
FACTORY
SETTING
DESCRIPTION
Arming & Disarming Beeps 1 ON 1 beep on Arm & 2 beeps on Disarm.
Door Lock on Ignition
(Anti-Hijack)
3 OFF When this feature is on, the doors will lock when the ignition
is turned to on, and unlock when the ignition is turned to off.
No Door Ajar Warning 4 OFF When this feature is on, the door ajar warning feature is
removed (the siren & indicators will not beep & flash for 3
sec. if a door is not closed properly).
Perimeter Night Light 5 OFF When this feature is on, the indicators will stay on
constantly for 20 seconds on disarm, or until the ignition is
turned on. This allows for illumination around the vehicle at
night.
Instant Boot Release 6 OFF When this feature is on, the boot release button (Left
Button) will only require be pressing once rather than
holding down for 3 seconds to open an electric boot.
Dome Light Extension
(Interior lights on when
ignition off, interior lights on
when system disarmed via
remote).
Note: This feature
cannot be turned on if Auto-
Rearm & Relock is activated.
See register 2.
8 OFF The dome (interior) light comes on automatically when the
system is disarmed via remote, enabling the owner to verify
the vehicle is safe inside. The light stays on for 20 seconds,
or until the ignition is turned on. The dome (interior) light
also comes on automatically when the ignition is turned off,
enabling the owner to quickly gather belongings before
exiting the car. The light stays on for 20 seconds, or until
the system is armed via remote, or until the ignition is
turned on again.
Shock Sensor Adjustment 11 6
SELECT
the level
required.
After pressing the remote 11 times to enter this mode, turn
the ignition to off. There are 8 levels of adjustment. The
factory default setting is level 6. Pressing the remote once
will increase the sensitivity by one level i.e. to level 7. The
LED will then flash seven times to confirm the new level.
Pressing the remote again will increase the sensitivity to
level 8 (max). Pressing the remote again will return the
adjustment to level 1(least sensitive). Once you have
adjusted the sensitivity level to the desired setting, turn the
ignition on to exit this mode.
Installer Mode 12 SELECT
The Mode
Required
After pressing the remote 12 times to enter this mode, turn
the ignition to off. This mode allows the installer / owner to
verify that each trigger of the alarm system is working,
without having to arm & disarm the system each time & set
off the siren. The siren will beep and the blinkers will flash
to indicate a trigger eg push the bonnet switch, open a door,
hit the vehicle. The siren will beep four times to indicate a
pre-warning impact sensor detection, or once to indicate full
alarm trigger level. Turn the ignition to on to exit this mode.