OPERATION INSTRUCTIONS FOR
ROLLING CODE ALARM: RA96
INSURANCE APPROVED SPLIT SYSTEM MODEL WITH
ENGINE IMMOBILISATION AND BOOT RELEASE
MADE IN AUSTRALIA
EMERGENCY PANIC BUTTON OPERATED VIA REMOTE
The panic feature is activated by pressing the right button on the remote control
transmitter for 3 seconds. This sets off the siren. To cancel “panic”, press the
right button on the transmitter for 1 second. NOTE: Panic does not work when
the ignition is on by requirement of Australian Law (EPA).
L
R
TO ARM/DISARM ALARM
The alarm is activated by pressing the
RIGHT
button on the remote control transmitter. The
blinkers will flash once, and the siren will beep once. The dash LED-light will stay on for 20
seconds then flash, THE ALARM IS NOW ON. To deactivate the alarm, press the
RIGHT
button again. The blinkers will flash twice and the siren will beep twice. THE ALARM IS NOW
OFF.
For audible arm / disarm
use the
RIGHT
button.
For silent arm / disarm
hold
BOTH
buttons down for approximately
4 seconds
.
PAT™ PAST ALARM TRIGGER MEMORY
If the alarm was triggered by an intruder while your alarm was set, it will beep the siren and
flash the blinkers four times on disarm. The system will also store the ten last times the alarm
has been activated in its memory, and can tell you what has triggered the system. Please refer
to “Features used by Installers/Servicemen” contained later in this instruction.
DOME LIGHT EXTENSION
The interior light will be automatically illuminated for 20 seconds when the driver disarms the
alarm. This allows the owner to verify that the vehicle is safe to enter plus giving the added
convenience of being able to see inside the vehicle even when the doors are closed. The interior
light will automatically turn off if the ignition is turned on, or if the alarm is armed again. This
feature is automatically disabled when passive arm and auto rearm are enabled.
DOOR AJAR WARNING FEATURE
If the vehicles doors are not properly closed when you try to activate your alarm system, the
blinkers will flash and the siren will continuously beep for 3 seconds to alert you that the
vehicle is not secure.
