Page 4
HD-6500 and HD-7000 Instructions;
See Illustration 3.1.
Locate the two top-most and rear-most
screws on the side of your HD-
6500/7000. Inserting the short end of
the Allen wrench into the screw head,
remove the two screws.
HD-7700 Instructions;
See Illustration 3.2.
Locate the two top-most and forward-
most screws on the side of your HD-
7700. Inserting the short end of the
Allen wrench into the screw head,
remove the two screws.
Both HD-6500/7000 and HD-7700 Instructions cont...
Store the two screws removed from the punch. Locate one of the
Interface Blocks and orient it against the two now-available holes.
Orient the block so that the interface block oval hole (1) is forward
and the counter bores face out. To the right is an example of a
counter bore. Use the longer ¼”-20 socket head screws provided to secure the
Interface Block to the machine with the short end of the Allen wrench. Tighten the
rear screw first then the forward screw. Repeat this step on the other side of your
punch with the other block.
Illustration 3.1 Illustration 3.2
See illustration 3.3.
Place your HD-4470 onto your punch and secure with the 4 three winged knobs
(1) as shown. Attach the handle (2) with the brass bolt, nylock-nut, and washer
provided in the accessory kit.
Illustration 3.3
