Page 2 of 2
RLRM Rubber Ladder Mount
3
Place the Ladder Rack onto the Roof Racks. Use the Locking Tabs to secure the rear and middle of the Rack to the Cross-
bars as per the Slide Ladder Rack instructions. Install the front of the Rack to the vehicles front Crossbar as shown below.
Place the installed Rubber Mounts into the
front Crossbar. Angle the Channel Nut so that
it will sit inside the Crossbar.
Side View: The Ladder Rack
must sit on the Rubber Strip
in the Crossbar.
Rubber Strip
must be
installed to
sit under the
Ladder Rack
at the front of
the vehicle.
Rubber Strip.
Crossbar.
Slide Ladder Rack.
Rubber
Mount.
Note:
Locking
Tabs are
not used
on the
inside of
the front
Crossbar.
Fix the Ladder Rack to the rear and middle
Crossbar as per Slide Ladder Rack
instructions.
4
Be sure the Channel Nut is located correctly across the
Crossbar. Tighten with a 13mm Socket Wrench.
5
Tighten the Rubber Mount to the Slide Ladder with a
13mm Socket Wrench. Be sure all fi xtures on the Rack
System are secure before use.
Rhino-Rack
3 Pike Street, Rydalmere,
Document No: R1083
Fit Time: 15min
NSW 2116, Australia.
Prepared By: Kayle Everett
Issue No: 01
(Ph) (02) 9638 4744
Authorised By: Chris Murty
Issue Date: 19/07/16
(Fax) (02) 9638 4822
These instructions remain the property of Rhino-Rack Australia Pty. Ltd. and may not be used or changed for any other purpose than intended.
