Page 2 of 3
RCP63-BK Base Kit
Instructions
Apply masking tape to the approximate working area on
the vehicle.
1
2
Parts List
Item
Components Qty
Part No.
1
Short Fixed Mount Rotation Block
2
M835
2
Short Fixed Mount Base Cover
4
M836
3
Short Fixed Mount Base
2
M834
4
Short Fixed Mount Flat Rubber
2
M837
5
Nutsert
4
H059
6
M6 x 30mm Hex Hex Setscrew
2
B202
7
M6 x 25mm Torx Screw
4
B244
8
M6 Curved Nut
2
N060
9
M6 Spring Washer
6
W004
10
M6 x 12.5 Flat Washer
4
W003
11
M6 x 16mm Flat Washer
2
W031
12
T27 Torx Key
1
H054
13
Instructions
1
R1587
Tools Required:
10mm socket
wrench. Masking tape. Drill with 9mm/6.5mm drill but. Nutsert
tool. Butyl mastic.
Note:
Legs and Crossbars are sold sepa-
rate. Be sure to obtain correct kits for your vehicle.
105mm
80mm
Locking RVL Low Leg
Locking RVH High Leg
1.
2.
3.
4.
5.
6.
7.
8.
10.
9.
11.
12.
Place the short fi xed bases into position
on the vehicle, Spot mark the outer two
mounting points in each base.
Using a 9mm drill bit,
open out the references
made previous.
3
4
Vacuum any swarf caused from drilling.
Remove the masking tape and apply cold galvanising
paint to the drilled areas in the vehicle. Allow 15min to
dry.
5
Apply the Paint
inside
EACH
drill
point. Make sure to
cover the entire
length of the hole.
Drill out the holes in the base as shown with a 6.5mm
drill bit.
6
