Page 1 of 5
43107 Rhino Jerry Can Holder
43108 Rhino Jerry Can Holder - Horizontal
Important:
Please read these instructions carefully prior to installation.
Check the contents of kit before commencing fitment and report any discrepan
cies.
Clean the alloy tray prior to installation.
Place these instructions in the vehicle’s glove box after installation is complete.
Recommendations:
Use only non-stretch fastening ropes or straps. Do not overload your Rhino-Rack Alloy Tray and roof bars. Check your
vehicle’s roof carrying capacity. Exercise caution when driving off road as vehicle roof height has been increased.
Caution:
The handling characteristics of the vehicle change when you transport a load on the roof. For safety reasons, we
recommend exercising extreme care when transporting large wind-resisting loads; special consideration must be taken
into account when negotiating corners and under braking.
Note for Dealers and Fitters:
It is your responsibility to ensure instructions are given to the end user or client.
Rhino-Rack
3 Pike Street, Rydalmere,
NSW 2116, Australia.
Document No: RR242
(Ph) (02) 9638 4744
Prepared By: Nigel Greig
Issue No: 08
(Fax) (02) 9638 4822
Authorised By: Chris Murty
Issue Date: 30/06/2015
These instructions remain the property of RhinoRack Australia Pty. Ltd. and may not be used or changed for any other purpose than intended.
Important Information
Layout
Internal Dimensions:
43107
Vertical:
366 x 170mm
43108
Horizontal: 480 x 170mm
CONTROLLED
