rheemthermal.com.au
INSTRUCTION SHEET FOR
PROGRAMMING ‘DEMAND HEAT’
13.
Press and release .
14.
Press and release or until
‘F. Service’
is selected.
15.
Press and release . and enter the four digit password
‘0022’
(Set first digit then press
to move to the next digit etc.). When the last digit has been set press and release.
Note:
This step will not occur if the password has been previously entered within 10 minutes.
16.
Press and release or until
‘C. Thermoregulation’
is selected.
17.
Press and release .
18.
Press and release or until
‘C. Thermoregulation 06’
is selected.
19.
‘Enable Unit On / Off ‘ screen will be displayed.
20.
Press and release to move cursor to ‘Yes’ on the right of ‘By Flow Switch’.
Should be flashing.
21.
Press and release or to select ‘No’ as appropriate.
22.
Press and release .
23.
Press and release or four times to go back to the home menu.
24.
Press and hold or for 2 seconds to clear all active alarms.
The Rheem Thermal heat pump is now programmed and ready to use with the
Rheem IQ
®
- Link DPi Digital Pump Interface Controller.
The
‘Cycle to Test Temperature’
function should be set at the time of installation by the
installer and does not normally require changing.
Controller set up is completed.
Australian
Standard
AS/NZS 2712
Lic SMK 0757
Lic SMK 1048
Lic SMKP 21548
SAI Global
AS 3498
Lic WMKA 00153
Lic WMKA 00177
Lic WMKA 00299
Lic WMKA 00500
Lic WMKA 21434
Lic WMKA 21549
Lic WMKA 21766
SAI Global
Quality
ISO 9001
TM
Materials and data subject to change without notice due to ongoing product
improvements. Rheem Thermal is a division of Rheem Australia Pty Ltd.
HEAD OFFICE
Rheem Thermal Systems Group
43 Marigold Street, Revesby NSW 2212
PO Box 146 Moorebank NSW 1875 Australia
Sales:
1300 132 950
Service: 02 9684 3684
Intl:
+61 2 9684 3684
Fax:
(02) 9684 3698
Email:
Web:
www.rheemthermal.com.au
ABN:
21 098 823 511
