ASSEMBLY INSTRUCTIONS:
1.
Gently turn both bases (B) upside down with inside surfaces facing each other
and leave enough space to assemble the stretcher (C&D) in-between as
shown in FIgure 2.
2.
Secure the threaded rod (1) to the fixed nut on the base (B) by simply turning it
manually.
3.
Raise the top stretcher (C) and set it in the cavity; place the rod (1) to align with the
holes on the end of the stretcher (C). Position the stretcher (C) against the base (B)
so the threaded rods (1) go through the holes. Insert curved washer (2) and lock
washer (3) and place hex nuts (4) on threaded rod (1), then tighten the hex nuts (4)
with wrench (5), as shown in FIGURE 1.
4.
On inside surface of the bases (B) there is a cavity for the stretcher (D) with holes
for the wooden dowel to pass through that correspond to the holes on both
ends of the stretcher (D). Install the stretcher (C) into the cavity of the base (B) and
once the stretcher is set engage Allen bolt (6) together with Lock washer (3) and
Plain washer (7). Please see FIGURE 2.
5.
KEEP HOLDING THE BOTTOM STRETCHER (D)
while repeating steps #2 - #4
for the other base (B).
6.
After assembly, gently turn the base upright and place in your desired location.
7.
On mounting plate of base are pre-installed locator blocks that fit on the frame
underneath the tabletop. Gently lift up the marble top (A) and install on top of the
base; engage Allen head bolt (9) with lock washer (10) and plain washer (11)
underneath the mounting plate of the base. Please see FIGURE 3.
8.
Assembly is complete.
St. James Marble - Page 2 of 2
10/1/18
ST. JAMES 96" & 108" MARBLE DINING TABLE INSTRUCTIONS
