IXTAPA & TOLUCA PROPANE TANK COVER OWNER’S MANUAL
SET-UP
7
PRE-ASSEMBLY INSTRUCTIONS
Before beginning assembly, you should check that
all gas connections are still tight and that there are
no gas leaks.
WAR N I N G
Before assembling the propane tank cover and using
the fire table, make sure you have read, understand
and are following all the information provided in the
“Safety Instructions” section of this manual. Failure
to properly follow the instructions may result in
property damage, personal injury or loss of life.
PERFORM A LP GAS LEAK TEST
Make sure control knob is
OFF
.
Turn LP gas cylinder
ON
at valve.
Prepare a leak checking solution by mixing 1 part
dishwashing soap with 3 parts water in a spray
bottle. Spray leak solution on valve connections
paying particular attention to the areas indicated
on
Figures A & B.
If any bubbles appear turn LP gas
cylinder
OFF
, reconnect and re-test. If you continue
to see bubbles after several attempts, disconnect
LP gas source and contact 1-800-762-1005 for
assistance.
If no bubbles appear after one minute turn tank
OFF
, wipe away solution and proceed.
CHECK LP GAS CONNECTIONS
Make sure the regulator valve and hose connections
are securely fastened to the burner and the tank. If
your unit was assembled for you, visually check the
connection between the burner pipe and orifice.
Make sure the burner pipe fits over the orifice.
WAR N I N G
Failure to inspect these connections or follow
instructions may result in a fire or an explosion,
which can cause property damage, personal injury
or loss of life.
Please refer to diagrams for proper installation.
If the burner pipe does not rest flush to the orifice
please contact 1-800-762-1005 for assistance.
POSITION LP GAS SUPPLY HOSE
Feed the propane supply end of the hose up
through the bottom of the tank holder base as
shown in
Figure C.
DO NOT feed the hose through
the center circular portion of the base (this is where
the propane cylinder will be seated).
Place the propane cylinder in the circular portion
of the metal base (
Figure D: #1)
and secure it by
tightening the two thumb screws in the base as
shown (
Figure D: #2).
PLACE & SECURE LP GAS CYLINDER
To Fire Table
To Fire Table
1
2
2
2
Figure A
Figure C
Figure D
Check for leaks at valve under table.
Figure B
Check for leaks at gas connection.
