TEXTURED METAL SWING-ARM SCONCE – ASSEMBLY INSTRUCTIONS
PARTS ENCLOSED:
(A) Wall Anchors (2)
(H) Plate Screws (4)
(B) Mounting Plate (1)
(I) Back Plate (1)
(C) Wall Screws (2)
(J) LED Bulb (1)
(D) Top Cord Cover (1)
(K) Arm Knob (1)
(E) Electrical Cord (1)
(L) Shade Joint (1)
(F) Bottom Cord Cover (1) (M) Arm Handle (1)
(G) ON/OFF Rotating Switch
TEXTURED METAL SWING-ARM SCONCE
Plug-In Installation
IMPORTANT SAFETY INSTRUCTIONS:
The fixture can be used as a plug-in or a fixed unit when used with the appropriate
conversion kit. For your safety, this sconce is equipped with a 3-pronged polarized
plug. If the plug does not fit securely into your outlet, do not force it – contact a
professional electrician. Use the plug with an extension cord only if it can be fully
inserted into the cord's socket. Never alter the plug in any way.
This fixture has been rated for up to (1) 4w max Type T LED bulb (included) or (1) 40w
max Type T incandescent bulb (not included). To avoid the risk of fire, do not exceed
the recommended wattage.
WARNINGS:
All wires are connected. When unpacking, be careful not to pull wires, as a bad
connection may result. Do not connect electricity until the sconce is fully
assembled. To reduce the risk of fire, electrical shock, or personal injury, always
turn off and unplug lamp and allow it to cool prior to replacing lightbulb.
Do not touch bulb when fixture is turned on or look directly at lit bulb.
Keep flammable materials away from lit bulb.
DO NOT REMOVE THE CARDBOARD INSULATOR SURROUNDING THE SOCKET.
THIS PRODUCT IS NOT A TOY AND HAS NO PLAY VALUE.
PLUG-IN ASSEMBLY INSTRUCTIONS:
1. Carefully remove all parts from the box and remove all plastic coverings.
2. Drill 2 holes in the wall that align with the holes on the mounting plate (B) of
the fixture and insert wall anchors (A).
3. Place mounting plate (B) onto the wall anchors (A), then screw wall screws (C)
into anchors.
4. Attach the back plate (I) to the mounting plate (B) and use the plate
screws (H) to secure.
5. Screw the top cord cover (D) into the hole located on the bottom of the back
plate (I).
6. Screw the bottom cord cover (F) into the top cord cover (D).
7. Insert (1) LED bulb (J) into the threaded socket.
8. Adjust the shade with shade joint (L) using arm knob (K) and arm handle (M) to
get the desired angle and height. Follow these steps to adjust the knob:
A. To adjust the position of the arm, lift up the arm handle to loosen the arm knob.
B. After loosening the arm knob, adjust the arm to the desired angle, then tighten
the knob. You don't need to tighten the knob with much force; just push the arm
handle down a little to hold the lamp in position.
9. Plug electrical cord (E) into proper electrical outlet and rotate ON/OFF switch (G)
to test fixture.
CARE INSTRUCTIONS:
To clean, use a soft, dry cloth only.
Do not use polishes or cleaners on the fixture.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3 years of age.
