Lock washer
DETAIL B
Hexagon nut
Plain washer
Mattress bolt
Allen wrench
HARDWARE FOR STEP #2:
(BB) 1/4" X 1-1/4" BOLT = 8 PCS
Hexagonal nut = 8 pcs
STEP #2
MATTRESS SUPPORT ARM ASSEMBLY
STABILIZER RAIL ASSEMBLY MATTRESS
HEIGHT ADJUSTMENT
Open wrench = 1 pc
Allen wrench = 1 pc
DETAIL C
Hexagon nut
Lock washer
Plain washer
(BB)
STEP #2.1
Lay Mattress Support flat with Stabilizer Rail on each side
Note
:
On each end of the arm of the Mattress Support, there is a hole for the
bolt to pass through that corresponds to the holes located in the frame of
the Mattress Support.
STEP #2.2:
Insert the bolt into the desired hole of the frame through the hole on the
arm support. Fasten the bolt with plain washer, lock washers &
hexagonal nut provided. Repeat procedure on other arms of the
Mattress Support. Please see
DETAIL B
.
WARNING
:
Set the Mattress Support to the desired height by adjusting the Support
Arms. The Mattress Support should be at its highest setting for
newborns, then adjusted to the lower positions as the child grows and
becomes mobile. Once the child is able to stand, the Mattress Support
should be at its lowest position.
STEP #2.3:
Install the Stabilizer Rail at ends of the arm support, as illustrated on
DETAIL C
.
Lock Washers 1/4" = 8 pcs
Plain Washers 1/4" = 8 pcs
7/9
Summary of Contents for Wyler Crib
Page 1: ...1 1 1 9 ...
