3
2
INSTALLATION AND SETUP
2.1
PRIOR TO SETUP
1.
Examine your canopy upon receipt and check that it is complete and undamaged. Refer to the parts lists in Chapter 4.
Report any shipping damage on the delivery receipt and contact the delivering carrier to file a damaged freight claim.
Do not install the canopy if it shows any signs of damage.
2.
Read and know the instructions and ensure that everyone understands the proper installation procedure.
3.
Do not install the canopy under the influence of drugs, alcohol, or medication.
4.
Do not try to install the canopy in rough water conditions or high winds.
5.
Ensure that the lift frame is square and that the lift sets level.
2.2
INSTALLATION PROCEDURE
The part reference numbers used in the subassembly drawings of this section are the same as those listed in the parts lists of
Chapter 4.
1.
Refer to
Figure 2-1
. Insert the opposite end of canopy extension leg (8) into top of vertical leg of lift. Adjust canopy
extension leg to a position that is most suitable for your boat lift installation and fasten in place. Perform this assembly
for each vertical leg as shown below.
Figure 2-1.
Canopy Leg Assembly
2.
Refer to
Figure 2-2
. Assemble both sides of your canopy frame on the ground using (1 ea.) left hand (3), right hand
(2), and center (1), stringers for each side assembly. Canopy rib bushings are offset to the outside of stringer face.
Make certain that all stringers are positioned properly. Fasten each joint together with hardware shown to inside
stringer face. Each stringer assembly MUST be straight for proper fabric fitting.
