A D V A N C E D S E T U P
Output Timing
350-8799
MediaWall 2000 User’s Guide
50
. . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
OUTPUT TIMING
MediaWall 2000
supports a wide range of pre-defined output formats
including the majority of standard VESA formats.
Figure 4-10.
WCP Setup Output Timing Page
VIEWING CURRENT
. . . . . . . . . .
TIMING SETTINGS
The timing parameters displayed in the upper section of the page relate
to the selection in the drop down box which may not be the same as
those currently used. To view the current settings click in the check box
Show Timing Values
and the current values will be displayed in red in
the associated parameter boxes.
LOADING FROM THE
. . . . . . . . . .
TIMING LIST
If you know the timing parameters of the output signal for the display
device you can manually load the timing from the either the factory
timing list or the user defined timing list.
Use the following procedure to load a new output timing set.
•
Click the
Setup
menu.
•
Click on the
Output Timing
tab (Figure 4-10).
•
Click on the scroll button in the Timing List section and scroll
through the list to the required timing entry.
For a list of pre-defined timing parameters please consult the
MediaWall 2000
Technical Reference Manual.
•
Click the
LOAD
button to accept the selected entry in the list.
