Rev 7.21
10
Once the Reader is done updating the settings, turn the unit off for 5 seconds and then back on. Wait
until the light on the left of the Ethernet connector is stable and solid and then go back to the
DeviceInstaller program and click search. Follow the same steps you used to change Serial and
Connection settings, however this time do not click OK. You are simply verifying the changes have
taken effect. Setup is finished. If you like, you can use the supplied terminal program (or your own)
to test communications with the Reader.
7.0 Power Requirements
7.1 Interface operating voltage
The interface unit requires 24VCD+ and 200mA max
7.2 Antenna operating voltage
Antennas operate at 24VDC+
Each antenna consumes 160mA max
8.0 Factory Switch settings
Switches 1, 2, and 3, are set at the factory for 16 characters read write Smart Antenna operation,
do not change this!
Switch 1 = OFF
Switch 2 = ON
Switch 3 = OFF
