INTRODUCTION
Thank you for purchasing this RFI Outdoor Panel Antenna. The antenna offers high gain, multi-band performance
covering all cellular networks in Australia (7dBi at 824-960MHz & 10dBi at 1800/2100/2400MHz). It is designed to
provide extra signal strength to your wireless broadband service or mobile phone and can be mounted either inter-
nally or externally.
IMPORTANT:
For maximum signal, we recommend external mounting to reduce signal losses caused
by building structures etc.
CONTENTS
Before assembling and installing your antenna, please check your kit including all the following components.
- Panel Antenna with 30cm lead terminated with female ‘N’ type connector.
- 10 metre low loss RG58 cable terminated with male ‘N’ type & male SMA connectors.
- Strip of weather proofing tape.
Pole mounting kit containing:
1 x ‘L’ bracket
3 x hexagonal nuts
3 x spring washers
1 x ‘U’ bolt
1 x Clamp
2 x hexagonal nuts
2 x spring washers
2 x flat washers
Wall mounting kit containing:
1 x wall plate
1 x antenna plate
1 x swivel bar
2 x Philips head bolts
2 x hexagonal nuts
2 x Philips head self tapping screws
2 x wall plugs
INSTALLING THE ANTENNA
Mounting Location
To get optimum performance from the antenna it should be pointed towards the strongest available network signal
(base station).
-
Connect the antenna to your data card or modem. The antenna comes ready to connect to devices
using an SMA type connector. For devices using other connector types, a patch lead to connect the
antenna (SMA) to the device (phone or data card) will be required (not included). Please contact you
retail or network provider for availability.
IMPORTANT:
Some data cards or modems will only detect the connection of an external antenna on power up.
We recommend you turn off your system and power up again after you have connected the antenna.
-
Once you have connected to the network, check the signal strength* indicator on your
computer.
