TX Pole User Manual
Page
14
of
24
–
Version 1
–
Status
–
ISSUED FOR USE
Document Number
–
PRJ-TXP-MAN-002
2.3.1
Modifying parameters with the TX Pole web interface
The settings described in table 6 can be set up on the TX Pole and on any modem it may be bond to
by using the browser interface. The TX Pole will appear as local and the aircraft modem as remote.
Click on
‘
View/
Edit 900x Radio Setup
’ to access the modem’s setup interface of
figure 6. If the TX Pole
has not been paired yet with any other modem, the remote side will appear empty and the message
“Sorry no parameters available”
will be shown.
Figure 6
–
T Pole modem configuration page.
Settings can be refreshed
using the ‘
Load Fresh parameters
’ button. Parameters can be adjusted in
the text boxes as required and then applied by means of the ‘
Save parameters
’ button.
Changes on
the AIR_SPEED, NETID, TXPOWER, MIN_FREQ, MAX_FREQ and NUM_CHANNELS parameters should
be applied to remote radio settings as well to avoid losing the radio link.
2.4
Firmware Update
Updating the TX Pole requires
two different files; the ‘firmware.bin’ and the ‘spiffs.bin’ files
which can
be found through the links in
. Before proceeding with the firmware update ensure the device
is charged at least 80%. On the browser configuration landing page shown in figure 2
, select ‘
Update
Firmware
’ and follow the on
-screen commands on figure 7 to flash the files onto the device.
