TX Pole User Manual
Page
11
of
24
–
Version 1
–
Status
–
ISSUED FOR USE
Document Number
–
PRJ-TXP-MAN-002
2.2.3
Wi-Fi Troubleshooting:
If you forget your settings or the device is not available on the network, resetting your TX Pole unit to
default settings may be required. This is done by pressing the button 5 times rapidly within 5 seconds.
The TX Pole unit will then reset to factory default configuration and reboot.
In some cases, user connection settings may prevent devices from accessing the Wi-Fi addresses. It
may therefore be necessary to do some basic troubleshooting such as removing the existing network
settings from the device memory, resetting the wireless adaptor, turn off mobile data and disconnect
other networking devices such as LAN cables. In other cases, running the Windows Network
Diagnostics may help.
2.3
TX Pole Internal RFD900x Modem settings
A description of the parameters that define the communication between TX Pole and remote RFD900x
modem is presented in
. For further information regarding the internal
modem on which the TX Pole is based on, refer to the
RFD900x Peer to Peer Firmware
and
RFDesign
Modem 900x Datasheet
Table 6 - RFD900x parameters
Reg
#
S Register
Description
Default
Value
Maximum
Value
Minimum
Value
Must be the same
at both ends of
the link?
S0
FORMAT
This is for EEPROM version, it should not
be changed. It is set by the firmware
Firmware
dependant
N/A
N/A
No
S1
SERIAL_SPEED
Serial speed in ‘one
-
byte form’.
Accepted values are 1, 2, 4, 9, 19, 38, 57,
115, 230, 460 and 1000 corresponding to
1200bps, 2400bps, 4800bps, 9600bps,
19200bps, 38400bps, 57600bps,
115200bps, 230400bps, 460800bps and
1000000bps respectively.
57
1000
1
No
S2
AIR_SPEED
1
Air data rate in ‘one
-
byte form’.
Accepted values are 12, 56, 64, 100, 125,
200, 224, 500 and 750 corresponding to
12000bps, 56000bps 64000bps,
100000bps, 125000bps, 200000bps,
250000bps, 224000bps, 500000bps and
750000bps respectively.
64/200
4,8
750
12
Yes
S3
NETID
Network ID.
25
255
0
Yes
S4
TXPOWER
1
Transmit power in dBm.
30
30
0
No
S5
ECC
2
Enables or disables the Golay error
correcting code.
0
1
0
Yes
S6
MAVLINK
3
Enables or disables the MAVLink framing
and reporting
1
1
0
No
