QS-TRAP-SHUFFLE-R2
TRAP-SHUFFLE: Game Simulator
Erasing the system:
1. First put the Transmitter into pairing mode : press switches 1,4,2, 3 in succession.
2.
The LED’s on the transmitter will flash alternately to show the unit is in Pairing mode.
3. Press and hold the Grey multi release switch for around 10 seconds.
4. The 2x LEDs at the top of the transmitter will illuminate together until the button is released.
5.
When the switch is released the LEDs will flash together to confirm the erase and exit pairing
mode.
Wiring of the system:
Installation Notes
An ideal installation would be to firmly fix the TRAP-SHUFFLE-RX approx. 2 metres from the
ground, in direct sight of the transmitter. Lowering the height or having obstacles between
transmitter and receiver will reduce range!
Connecting Power to the Receiver unit
The receiver unit requires the following connections to operate:
- 12V supply (Brown wire as supplied)
- OV Supply (Yell/GRN wire as supplied)
When the Receiver unit has power connected the Power LED will illuminate. This must be ‘on’
for the system to operate.
Power in 12-32V
NO/COMM/NC Relay
Terminal
Buzzer
Reed Switch (for easy pairing)
Learn Button
Antenna Connection
Status LEDs
Momentary/ Latching
Jumper Links
Power LED
Receiver Wiring
This diagram shows the
standard wiring configuration.
This may need to be adapted to
fit traps of other switching
types.
QS-TRAP-SHUFFLE-R2
TRAP-SHUFFLE: Game Simulator
Check the Wiring required for your Trap:
The TRAP-SHUFFLE-RX is capable of switching nearly any trap type, however wiring conventions
vary between manufacturers. The relays on the TRAP-SHUFFLE-RX can switch up to 24V DC or
230V AC @ 5A.
Wiring a Plug
The Receiver is supplied with a 3 core cable where:
•
BROWN
—
12V
•
GREEN/YELLOW
—
0V
•
BLUE
—
Trigger Wire
A plug can be wired to the cable to be connected to many TRAP models. The image below
shows wiring examples for two common TRAP manufacturers.
Promatic Hirschmann 4
You can find an instruction video with pairing instructions at the link below or via the QR
code. https://www.youtube.com/watch?v=ihe98aBVF7Y
This system is not compatible with the standard TRAP systems as it uses specifically
designed firmware for the flush functionality in both the transmitters and receivers.
Promatic Duraplug 3 Pin
Laporte 4 Pin
