HORNETPRO Remote Control System
NOTE: Installation should be carried out by a qualified technician
Getting Set Up:
Unscrew the 2 screws at the base.
Remove base panel.
Unscrew the antenna at top of enclosure.
Lightly pull the PCB inside to remove.
Relay
Relay
Relay
0
V
LO
A
D
1
2
V
12V
0V
COM
NO
NC
Supply
Terminals
TRAP-RX
Below is a simple example showing one possible way to wire a relay in order to give
switched power to an external load:
When the relay is energised the ‘COM’ connects to ’NO’ and power is applied
to the Load.
NOTE: For full installation instructions and product specification, please see the
HORNETPRO Datasheet at www.rfsolutions.co.uk.
HORNETPRO Remote Control System
NOTE: Systems come pre-paired. Pairing instructions only need to
be followed for additional transmitters.
With this system, you can pair together any individual transmitter
switch, with a receiver relay output switch. Without opening either
enclosure...
1. Briefly (for less than 1 second) place a magnet next to the
top left of the receiver as shown, and then remove it.
2. The receiver will buzz once (One buzz means the receiver unit
is ready to allocate a transmitter to relay switch 1).
3. Press the switch on the transmitter which you wish to pair.
4. The receiver will buzz twice to confirm pairing.
5. Repeat for any additional transmitter switches.
NOTE: Each receiver has a maximum memory for up to 28 pairings,
these can be from any switches on any transmitters!
To select relay outputs 2,2,4, repeat step 3 above and count the
number of buzzes. 2 buzzes for relay 2, 3 for 3 etc.
Advanced operation - Pairing a transmitter button
Setting the Outputs Momentary or Latching Operation
1
/
2
sec Mom = Relay will operate for
1
/
2
sec
Mom
= Relay will operate for as long as
transmitter switch operated
Latch
= Relay will toggle ON/OFF on each
transmitter button press
Link Positions
Switch relays
LK1
LK2
RLY 1
RLY 2
RLY 3
RLY 4
Open
Open
1
/
2
sec Mom
1
/
2
sec Mom
1
/
2
sec Mom
1
/
2
sec Mom
Closed
Open
Mom
Mom
Latch
Latch
Open
Closed
Mom
Mom
Mom
Mom
Closed
Closed
Latch
Latch
Latch
Latch
NOTE: If link setting is changed, power cycle the receiver (turn off/on) otherwise it will stay in
the same mode it was previously set in.
