HORNET 433MHz
DS HORNET-13
Pairing Transmitters to the HORNET-RX (12-32Vdc Version)
Please note that the HORNET Systems are provided ready to operate and Pairing a
transmitter to a receiver is only required when replacing or adding a new transmitter.
To pair a new transmitter switch follow this procedure
Note!: Any transmitter button can be configured to operate any of the receiver relays.
1. Select the receiver output relay to learn to:
2. Briefly press the receiver Pairing switch (S2) once
3. The Learn LED will flash once to indicate relay 1 is selected
4. After the LED stops flashing, press the Learn switch again to select the next
relay channel
5. Repeat step 4 until the required relay is selected.
6. Press the button on the transmitter you want to learn to the chosen relay.
7. The Learn LED will flash to indicate Pairing is complete.
Pairing a Transmitter to a Receiver
Each receiver has a maximum memory for up to 30 pairings, these can be from the
same or any number of transmitters.
Erasing Receivers Memory
1. Press and hold the receiver Learn Switch for approx 10 seconds.
2. When the Learn LED turns ON all memory is erased
NOTE: You cannot erase individual Tx encoders
