202 Industrial Series
202 Industrial Series
202 Industrial Series
202 Industrial Series
DS 202-1
©2009 REG No 277 4001, Lewes, England. Page 3
Installation guide
Installation guide
Installation guide
Installation guide
Transmitter set
Transmitter set
Transmitter set
Transmitter set----up
up
up
up
Power
Power
Power
Power
The 202 range of transmitters come with an on board lithium battery (CR2032) and connection for an
external DC source if required.
External power in the range 9—24V DC may be applied via the screw terminal marked DC input (Fig 1.1)
For estimated battery life figures see technical specifications page 7.
Wiring
Wiring
Wiring
Wiring
Installation of the 202 transmitter range is simply a case of connecting the input screw terminals to your
chosen switch and if required connecting the power supply
NOTE: Inputs are volt free, DO NOT connect power to the inputs.
Antenna Mounting
Antenna Mounting
Antenna Mounting
Antenna Mounting
The 202 comes with a BNC connector.
Auto TX Link
Auto TX Link
Auto TX Link
Auto TX Link
The 202 can be set to automatically transmit a “watchdog” signal, The Auto Tx feature sends the status
of all inputs to all associated receivers at a random time between 5 and 10seconds. The receiver will drop
out its signal fail relay within 20seconds of no communication.
The 202 has three Auto TX options: Off, Default and Forced.
•
Off—Remove the jumper link from the pins; the Auto TX is completely disabled.
•
Default—Cover pins 2-3 with the jumper link; the auto TX will only function when an external power
source is added. If external power fails the 202 will stop the auto Tx but will otherwise operate normally.
•
Forced—Cover pins 1-2; the auto TX with transmit at all times irrespective of the power source.
(CR2032 battery or external)
