RF Central microLite Transmitter, User Manual

Page: 33 / 38

microLite Transmitter User Manual
Revision 1.2
33
4.4.2.4 Video
The Video LED will display Green when Video is present on SDI input
connector. Blinking YELLOW indicates that no video input signal (composite
or SDI) is detected. This only detects the presence of video and does NOT
detect if the encoder supports the format applied. See Section 3.3 for supported
formats
4.5 Select User Level Settings
By use of the SET button, select an appropriate preset so that your MicroLite transmitter and
suitable receiver are on the same RF and modulation settings.
4.6 Put the unit in Transmit Mode
Press the TX / STBY toggle button to put the unit in Transmit mode. Pressing the button again
will put the unit in Standby mode (no RF output).
4.7 Select Power Level
Press the HI / LOW toggle button to select the power level desired. In HI mode, the unit will
output its full rated power. In LOW mode, the output will be approximately 6dB down from
the HIGH power output.
4.8 Operation Verification
Verify operation of the
microLite
by one of the following methods:
•
If your system contains a host processor capable of communicating with the microLite via
the serial interface, use interrogation commands to check the status of the microLite .
•
Detect the transmitted signal using a spectrum analyzer.
•
Using an appropriate receiver, verify that you are receiving audio and video from your
application setup.
4.9 Accessory Kit
The accessory kit with the MLT includes the following:
•
1 micro Lite HD Tx with transmitter mounting bracket and Litepanels kit - preassembled
•
1 Omni Directional Tx antenna
•
1Transmitter power cable set (Lemo to Tamiya)
•
1 Anton Bauer D-Tap power cable (D-Tap to Tamiya)
•
2 Audio cables (Telocate to XLR unbalanced)
•
1 USB-Serial adapters for configuring units (USB to RS-232)
•
1 USB/Power software update cable for system software updates for the MLT
•
1Transmitter power cable (Lemo to Tamiya/DB-9)
•
2 Instruction Manuals and NanoController Software on USB stick
4.10 Maintenance Information
Follow these procedures when maintaining the device:
•
Dry the device immediately if it is exposed to water or other liquids. Warranty does not
cover liquid damage.
•
Do not submerge the device or use it directly in rain.