!
1. Use a C
AT5 cable to connect to a receiver. Connect the receiver to an HDMI
display.
2. Use a HDMI cable to connect the source device to the HDMI input port and a
VG
A
cable to connect the source device to the VG
A
input port on the Unit.
Connect the stereo audio source to 3.5mm earphone jack ( if necessary)
3. Use an HDMI cable for connection between display and the HDMI output port
on the Unit (if needed).
4.
Apply the proper power to the Unit; then power on all the attached sources
and devices.
NOTE
: If users encounter no screen display in computer connection
2. Set your display device’s input source as HDMI.
4. Connect your computer to the HDMI Display DIR
E
CTLY to
check
if the video
signal gets through.
5. Slide the switches to the correct positions according to your displays.
6.
Apply EDID Copy to your display
(see EDID Setting section)
.
Installation
W
ARNING
● Ensure that all devices are powered o
f
f before connecting to the Unit.
● Make sure all devices you will connect are properly grounded.
Link Port Switch
Auto Power Saving: Automatically save energy when source or monitor connected
failure
Normal: Normal operation (up to 4K2K)
Long Reach:
Extend distance from 100M to 150M (up to Full HD 1080p)
(EVBMV-1391
L only)
