REXROTH IndraControl L25 CML...3N Series, Project Planning Manual

Page: 47 / 72

the IndraControl L25 off the top-hat rail from below, tilting it and removing it
upwards.
8.2 Mechanical Installation of Rexroth Inline Terminals
8.2.1 General Information
Rexroth Inline terminals can be added in series to the right of the IndraCon‐
trol L25 as appropriate. No tool is required. On connecting these modules in
series, the potential and bus signal connection (voltage routing and data rout‐
ing) between the individual components of the station is established automati‐
cally.
The terminals are mounted perpendicularly to the top-hat rail.
Once the station has been set up, individual terminals can be replaced subse‐
quently by being pulled out or plugged in without any additional tools.
Top-hat rail The Rexroth Inline terminals are mounted to the right of the IndraControl L25
on the 35 mm standard top-hat rail.
8.2.2 Mounting the Inline Terminals
Proceed as follows to latch on a terminal (see fig. 8-2 "Latching a terminal" on
page 46 ):
● First latch on the terminal that is required to set up the station, perpen‐
dicularly to the top-hat rail (see figure A).
Ensure that all feather keys and keyways of neighboring terminals
are interlocked (figure B).
The keyway/feather key connection connects neighboring modules to each
other. In this way the voltage routing is set up securely.
●
Then fit the connectors onto the respective terminal.
First fit the front connector shaft latch in the front release mechanism (figure
C).
Then press the connector towards the terminal until it clicks into place in the
rear release mechanism (figure D).
The keyways provided in the terminal are not continued in the con‐
nector. A terminal can only be latched on, if there is no connector
to the left of it. If necessary, the connector has to be removed.
DOK-CONTRL-IC*L25*****-PR03-EN-P
Rexroth IndraControl L25 Bosch Rexroth AG 45/69
Installation and Maintenance