REXROTH IndraControl L25 CML...3N Series, Project Planning Manual

Page: 48 / 72

A B
C D
Fig.8-2: Latching a terminal
8.2.3 Demounting the Inline Terminals
Proceed as follows to remove a terminal (see fig. 8-3 "Removing a terminal" on
page 47 ):
● Remove the labeling field, if present (A1 in figure A).
If any of the terminal is provided with more than one connector, all
these connectors have to be removed. The following sections de‐
scribe how to remove a 2-slot terminal.
Pry out the connector of the terminal to be removed by pressing on the rear
connector shaft latch (A2 in figure A).
●
Remove the connector (figure B).
● Remove the adjacent connectors of the neighboring terminals (figure C).
This ensures that the feathers of the voltage jumpers and of the keyway/
feather key connection are prevented from damage. Moreover, the termi‐
nal can be accessed more easily.
● Actuate the release mechanism (D1 in figure D) and remove the terminal
perpendicularly to the top-hat rail (D2 in figure D). If you have failed to
loosen the connector of the neighboring terminal to the left, this connector
now comes loose to protect the feathers of the voltage routing and the
keyway/feather key connection.
Bosch Rexroth AG DOK-CONTRL-IC*L25*****-PR03-EN-P
Rexroth IndraControl L25
46/69
Installation and Maintenance