REXON CT1800R, Instruction Manual

Page: 8 / 16

5
ADJUSTING DEPTH
CONTROL BRACKET (FIG. 11)
1. Turn the depth control lever (1) up to
loose; turn the depth control lever (1)
down to lock.
2. Turn the depth control lever (1) to adjust
to the required cutting depth.
Setting the Tool
WARNING! To avoid injury from an
accidental start, ALWAYS make sure
the switch is in the “OFF” position,
and the plug is not connected to the
power source outlet before making any
adjustments.
Connecting to the Power Supply
Check that the power supply and outlet
used is in accordance with your marble
cutter. Have a look at the rating plate of the
motor, if any changes should always be
carried out by a qualified electrician.
USING AN EXTENSION LEAD
The use of any extension lead will cause
some loss of power. To keep this to a
minimum and to prevent overheating and
motor burn-out, ask advice from a qualified
electrician to determine the minimum wire
size of the extension lead. If the power
cable is broken, repair service is available
at your nearest service center.
WARNING! Avoid contact with the
terminals on the plug when installing
(removing) the plug to (from) the power
supply outlet. Contact will cause a
severe electrical shock.
Operating the Tool
WARNING!
●
Never connect the plug to the power
source outlet until all installations and
adjustments are completed and you
have read and understood the safety
and operation instructions.
●
Be sure to move the marble cutter
forward in a straight line.
TRIGGER SWITCH (FIG. 12)
1. Press the trigger switch (1) to turn on
the marble cutter; release the trigger to
stop the marble cutter.
2. To maintain in a continuous operation,
press the trigger switch (1) and the lock
button (2) at the same time.
3. Press the lock button (2) again to stop
the marble cutter.
USING PARALLEL GUIDE RAIL (FIG. 13)
When doing a straight cut, parallel guide rail
would be a better accessory to apply with.
1. Loose two wing bolts (1).
2. Slide the parallel guide rail (2) to the
desired width and tighten the wing
bolts (1).
NOTE:
Make sure the wing bolts are
tight enough to avoid influencing the
cutting accuracy.
BASIC OPERATION (FIG. 14)
1. Mark the desired cutting line (1) on the
workpiece (2).
2. Hold the marble cutter firmly and align
the blade with the cutting line.
3. Turn on the marble cutter and wait to its
full speed.
4. Hold the machine firmly and move
forward in alignment with the cutting line.
WARNING! Forcing and applying
excessive pressure might allow the
blade to bend. Pinch or twist in the cut
can cause overheating of the motor and
dangerous kickback of the tool.