Deskside and Office 230v
37
26/05/99
ILLUSTRATED PARTS MANUALS
SERIES 7 SHREDDERS – 230v
DESKSIDE AND OFFICE MODELS
7.
Remove top (rear) tie bar, by unscrewing on fixing bolt at ‘bearing end’, and sliding it out of the
‘motor’ side plate.
8.
Unfasten four motor bolts (note – two, under the compound gear, are countersunk self-locking
type).
9.
Note angular position of the motors wires, then pull the motor out of its location in the side
frame and lift it out of the assembly.
Replacement
1.
Fit motor, on its spigot, into the side frame, with rear support bracket resting on the lower tie bar
and wires in their correct angular position.
2.
Insert motor fasteners ‘finger-tight’ (NB countersunk screws to be under the compound gear).
3.
Refit top tie bar, motor bracket properly located, and fit bolt at bearing end.
4.
Tighten motor fasteners.
5.
Replace compound gear on its shaft.
6.
Refit large gear.
7.
Refit gearbox cover assembly correctly on its locating pins.
8.
Replace and tighten all gearbox covers and tie bar fixing bolts.
9.
Replace cutting head into cabinet (Section 2)
10.
Fit top cover (Section 1)
11.
Test operation.
View with Main Gears removed
. Note motor
fasteners (A)
View of Cutting Head, 1150 Series
with Cover
Removed. Note cover fixing bolt (A) and longer top tie
bar (B)
A
B
A