REX Hyper Saw XS150S, Operation Manual

Page: 14 / 16

࡯ 13 ࡯
Table 3
Problem
˴˴˴˴˴˴˴˴
Probable Cause
˴˴˴˴˴˴˴˴
Remedy
Troubleshooting
W A R NING
࡮ If the problem you have and the appropriate remedy are not shown in the table below, do not attempt to disassemble or repair
the unit yourself.
࡮ If the problem and remedy are not shown in the table, or if the table indicates that you should have the unit repaired or serviced,
consult your distributor or REX.
࡮ If this product is repaired by someone who does not have the proper knowledge or technical skill to do so, the product may not
operate properly, or an accident or injury may occur. In the event of a problem, always check the table before contacting REX
Industries or your dealer.
Motor doesn't rotate. The carbon brushes are worn. Replace with new brushes.
Overload protection device has been
activated. Allow the machine to cool before using
again.
The power cable is damaged. The switch,
controller or motor is malfunctioning. Ask for repairs or servicing.
Motor stops while cutting. Overload protection device has been
activated. Allow the machine to cool before using
again.
Insufficient power.
The voltage is too low. Use the correct power supply.
Cutting takes too long.
Blade is worn.
Replace with a new blade.
Slanted cuts.
Blade is worn. Replace with a new blade.
To much force is applied when cutting.
Cut with appropriate force.
Too much vibration
when cutting.
Blade is damaged (chipped or cracked) Replace with a new blade.
The blade fixing-screw is loose.
The workpiece is not fixed securely.
Tighten the screw.
Tighten the workpiece securely with the
chain vice.