Warranty and Disclaimer:
All instructions must be read and understood. Seraph Enterprises, Inc. DBA Rex Silentium, Inc. warrants to the retail customer that this suppressor is free of defects in workmanship
and/or materials, and that this suppressor meets or exceeds all manufacturing specifications. This warranty for this suppressor only covers repair or replacement at our discretion.
THERE IS NO OTHER WARRANTY, EXPRESS OR IMPLIED. There is no warranty for the merchantability of nor the fitness of this suppressor for particular purposes.
Specifications and/or designs may change without notice. This warranty does not include or cover: careless handling or use; negligence; improper handling or use; attempted, partial or
complete disassembly; abuse; modifications; improper installation; ordinary wear as a result of normal use; use of improper ammunition; or any failure to follow instructions.
Rex Silentium, Inc. shall have no liability in any way for any damages or for any personal injury or death, economic loss, or damage to property.
BEFORE USING THIS SUPPRESSOR:
Make sure the firearm is unloaded and the safety is on. Read all instructions on this page for this suppressor. Failure to do so may result in serious injury or death! Always use extreme
caution when handling firearms and suppressors!
AMMUNITION:
Use only factory SAMMI approved ammunition with this suppressor. USE ONLY AMMUNITION OF CALIBER EQUAL TO OR SMALLER THAN THE CALIBER ENGRAVED
ON THIS SUPPRESSOR!
INSTALLATION AND REMOVAL:
NEVER INSTALL OR REMOVE SUPPRESSOR ON A LOADED FIREARM! Visually inspect and make sure the firearm safety is engaged, verify firearm is unloaded and remove
magazine if applicable. TO INSTALL: make sure muzzle threads and caliber correspond with the suppressor specifications. Carefully thread the suppressor onto the muzzle threads.
Hand tighten. DO NOT OVER TIGHTEN. From the rear of the firearm, visually inspect the bore with the suppressor attached to verify that the suppressor does not obstruct the bore of
the firearm. Never inspect bore alignment from the front of the firearm! TO REMOVE: ONCE THE SUPPRESSOR HAS COOLED TO ROOM TEMPERATURE, unscrew the
suppressor by hand. If necessary, use of a strap-wrench on the rear of the suppressor to loosen. NEVER ATTEMPT TO REMOVE A HOT SUPPRESSOR! KEEP HOT
SUPPRESSOR AWAY FROM FLAMMABLE AND COMBUSTIBLE MATERIALS!
MAINTENANCE:
SEE DISASSEMBLY AND REASSEMBLY INSTRUCTIONS.
REPAIRS:
Contact us before any return is attempted or shipped! To follow legal requirements, you must not ship your suppressor to us until we have reviewed your situation. BATFE REQUIRES
A LETTER TO SHIP WITH THE SUPPRESSOR WITH DETAILS ABOUT THE SERVICE OR REPAIR AND REQUIRES PROOF OF OWNERSHIP. YOU MUST PROVIDE A
COPY OF THE FIRST PAGE OF YOUR FORM 3, FORM 4 OR FORM 5 IN ADDITION TO THE REPAIR LETTER. A SERIAL NUMBER CANNOT BE TRANSFERRED TO A
NEW SUPPRESSOR OR TUBE.
Thank you for your purchase!
Rex Silentium, Inc.
Bozeman, Montana
406-624-0669
www.RexSilentium.com
(C) Copyright 2019
All Rights Reserved
SEG H PISTOL Suppressor Instructions & Configurations
