Schedule work standby mode
With scheduled work standby mode TK102-NANO is able to turn itself completely off and only
wake up at pre-set intervals. When it wakes up it will work for 5 minutes, report its location
(SMS or internet) and switch OFF. If you are using TK102-NANO in live internet tracking
mode and would like to use schedule work mode, do not forget to activate less gprs mode as
otherwise the auto update interval setting will override the standby. To activate send commands
below;
Command: spspace+time interval
Response: schedule ok
Please check below for time interval settings ; m = minutes , h = hours , d
= days . Maximum schedule setting is 30 days.
Please check Schedule work standby mode setting examples below;
schedule123456 30m
-- this will set the TK102-NANO to stay in standby and report its location for 5 minutes every
30 minutes.
schedule123456 12h
-- this will set the TK102-NANO to stay in deep sleep and report its
location every 12 hours.
Deep sleep / Start work at specific time mode will provide the longest standby duration as power
usage will be minimum due to both GSM and GPS modules being on standby at all times. 2
location reports per day will provide approximately 2-4 days battery life.
To cancel the schedule work standy mode:
Command: nospassword e.g.
noschedule123456
Switching standby modes OFF
Select the sleep mode that suits you best before starting to use your TK102-NANO. Real-Time
GPS Tracking consumes significant amount of battery power and standby duration of your
TK102-NANO will be reduced to 5-10 hours if there aren’t any standby modes active. To turn
switch all standby modes OFF;
command: sleep+pspace+off e.g.
sleep123456 off
Summary of Contents for TK102-NANO
Page 4: ...3 3 Bottom 3 4 Front 3 5 Interior ...
Page 22: ...19 ...
