M203 EIB/ KNX
Re:connect
6
Connection:
M203
with IR controller
Socket
IR- LINK
Connect the small
M204
IR
receiver, which is available in
four different models, to the
IR
Link.
Now you can locate the
M51
in a concealed location or
outside the normal range of
your remote control, without
having to forego any of the
convenience of using the
remote control.
The connection to an IR
receiver or a wall-mounted
remote control is done through
the 3-pin, screw-fixable Phoenix
plug connection.
Revox recommends the use of
a 2-core screened cable
(microphone cable), where the
screening is used as ground.
This cable may be a maximum
of 30 metres in length.
Please ensure that you use
the correct polarity when
setting up as otherwise you
might damage your
equipment.
Symbols:
+
Pos. voltage. 20V (DC)
IN
IR Signal
-
Ground
The maximum number of IR
receivers that can be switched
in parallel per
M203
is 3.
L
If you want to equip the
(additional) rooms with an IR
controller, you will need one
M204
IR receiver for each
M219
Additional room amplifier. You
will find further information on
this topic on page 11.
An
M218
wall-mounted remote
control, with integrated IR
receiver, can be connected
instead of the
M204
IR receiver.